Looking for Ventures Clone Pickguard!

[Roncore]

I've had one of these Fullerton MoVibe HH for years and decided to finally fix it up. The previous owner had butchered the Pickguard (actually the entire darn guitar if I may say so) so I'm on the hunt for a replacement. It looks like it's measuring around 12" from top to bottom. I did find the STL files for this, but my bed on my 3d Printer isn't large enough, and I haven't used a slicer before with something like this.

Are there any budget friendly pickguard places for clones these days?

Here is a link to a green version of the guitar, I have the Metallic red version.
https://reverb.com/item/15328008-fuller ... srite-copy

[101Volts]

I've had one of these Fullerton MoVibe HH for years and decided to finally fix it up. The previous owner had butchered the Pickguard (actually the entire darn guitar if I may say so) so I'm on the hunt for a replacement. It looks like it's measuring around 12" from top to bottom. I did find the STL files for this, but my bed on my 3d Printer isn't large enough, and I haven't used a slicer before with something like this.

Are there any budget friendly pickguard places for clones these days?

Here is a link to a green version of the guitar, I have the Metallic red version.
https://reverb.com/item/15328008-fuller ... srite-copy

Judging by the photo, it looks like the pickguard is very similar (if not nearly 1:1) the same as a Mosrite Ventures Mark V Pickguard. However, those aren't available just anywhere. I guess you might be able to buy one from Bob Shade at Hallmark Guitars, he might make one for you - however, I'm not sure that it would fit your Fullerton.

http://www.hallmarkguitars.com

I can suggest to print the pickguard on paper, then make a pickguard out of a blank with the pickguard being cut out of the paper. That's about all I can imagine now since I don't have a 3D Printer. You may need to take the file to a Staples and then have them print it 1:1 with the actual size of the pickguard.

- Austin