mosriteforum.com

Hey,

Just found these forums, and all I can say....It's about time! I've been searching for Mosrite stuff for a long time.

Okay, so I have a 66 Ventures Mosrite with the truss rod accessible at the top of the headstock. I'm trying to adjust it, but I need to know the size hex wrench to use...does anyone know? Also, it seems like the truss rod is loose. It turns real easy (I used needle nose pliers)....is that normal? Although it felt like the hex nut moved, I'm not sure it was moving the truss rod since the neck didn't seem to have anymore relief.

Thanks for your help.

Jim

Welcome to the forum. I used the Search feature at the top of the page and came up with this, Truss rod wrench. Hope that helps.

There's a lot of information about truss rods here on the website.