Page 1 of 1
pot shafts and knobs for MK V
Posted: Fri Oct 04, 2013 7:42 am
by TheEHMan
What shafts do I need on the pots for my MK V project? Also, which knobs would be correct?
Re: pot shafts and knobs for MK V
Posted: Fri Oct 04, 2013 9:41 am
by Mr. Bill
Split shaft Centralab pots, 300K with a 0.05uF ceramic cap. The knobs would be the taller standard Mosrite knobs, one marked with a V and one with a T.
Have you searched the forum here for info? There are a lot of posts regarding the Mark V and the pickups and the pots and the etc.
Re: pot shafts and knobs for MK V
Posted: Fri Oct 04, 2013 1:05 pm
by Dennisthe Menace
Mr. Bill wrote:Split shaft Centralab pots, 300K with a 0.05uF ceramic cap. The knobs would be the taller standard Mosrite knobs, one marked with a V and one with a T........
Actually the taller knobs have just the numbers on them....FWIW.....
Re: pot shafts and knobs for MK V
Posted: Fri Oct 04, 2013 6:59 pm
by Mr. Bill
My bad. I probably should have looked a set of knobs before posting. Thanks for the correction.
Re: pot shafts and knobs for MK V
Posted: Mon Oct 07, 2013 5:33 am
by TheEHMan
Thanks for your help! Looks like Bob Shade at Hallmark has every part I need for this project!