mosriteforum.com

A gentle member could answer me?
i need this dimensions to place my guard and the neck pickups to the end of neck (it will avoid my neck go behind the pups )
A=?
B=?
for the radius i will wait my pups to see it but with the 2 other dimensions i can beguin my template for body and neck


thanks by advance

Hi ludobag,

measured from an ed elliot border:

A = 10,1 cm
B = 4,8 cm

Best regards
Phil

thanks a lot

the one m3 pickup ring i have is slightly less wide then my mosrite originals. this may because i think the earliest mosrite pickup covers and rings were made this way. but then again it could have be due to shrinkage after the ring was made. not sure which.

thanks i have recept my pups since
faster than i expect in fact