mosriteforum.com

Dubtrub;
Would you mind sharing your Tremolo drawings. I would like to attempt one.
Dan

I'll try to find them as I haven't seen them in a few years. They were not a Mosrite, just something similar that I drew up. I think I have tracing of the outline of a Mosrite base plate somewhere around the shop or library.

I'm sorry but I can not find the drawings. That was a one time project and I swore I'd never scratch build another one again unless I sand casted one.

How did you do the textured cutout portion, looks like hammer and punch.?
Dan

I used a drill in a drill press. I set the depth and started drilling shallow divots inside the pre-marked area. Afterwards I used a small wire wheel in a hand drill to round the edges a give it the textured look. Once that was all done I polished it on a buffer.