mosriteforum.com

Does anyone out their in mosrite land know how the carve goes on the ventures II model? is it just a round over on the electronics side or is it carved like the opposite side? Need some help guys, want to get it right thanks.

I'll take a stab at it...I've only ever seen one up close at a friends house a long time ago. Didn't even touch it.
From what I remember it looked like a cove that went from the top cutaway and all the way around the edge and then stopped on the corner of the lower bout. No carve on the bottom edge. And then there was a small cove routing in the lower cutaway, but just on the inside from the neck pocket to about 2-3 inches from the top of the horn. I hope this makes sense....
Somebody correct me if I'm wrong.

This should help you;

viewtopic.php?f=20&t=267

Wow, thats a picture can"t go wrong now on the carve. I thought thats what the meaning on the cad print, but just wasn't sure, deffinately appreciate the help Jason, thanks a million Al

Bushers wrote:This should help you;

viewtopic.php?f=20&t=267

Jason, where the devil's name have you been? Good to here from you !

Been real busy since the beginning of this year, started a new job in Tulsa and not working from home anymore

I've been keeping up to date periodically, just haven't posted much! Still here!!

Hey Al, you wanted to see the size in comparison to a strat, here ya go!

Hay Jason, that looks just about right. The horn on the strat is just a shade longer than the mosrite. Thanks for taking the time to post the pic. Good luck in the new job. Al