I recently purchased a Celebrity I (hopefully i've got that right, it's the deep bodied version). I was playing it a couple weeks ago, and it completely cut out. I pulled the control plate off and didn't see anything glaring. I checked to make sure all wiring was still attached and that the jack was making good contact with the cable. Oh, and I checked the cable too, and it's fine.
At any rate, i'm thinking that I miht be better off replacing the guts. In a previous thread the pot specs were discussed, but not for a celebrity. Does anyone know if these are 250K or 500K?????
Also, what replacement pickups are available for a Celebrity? I prefer humbuckers, if they're available.
I'm also thinking about adding individual tone and volume control for each pickup. Does anyone know where I might find a good wiring diagram for this setup?
Thanks in advance for all of your help!
Celebrity Q's
-
- New Member
- Posts: 2
- Joined: Fri Aug 07, 2009 1:12 pm
- Location: Washington
- Contact:
- GattonFan
- Master Contributor
- Posts: 1287
- Joined: Tue Aug 26, 2008 6:36 pm
- Location: St Louis area
- Contact:
Re: Celebrity Q's
Before you get radical with the p'ups, you might want to consider letting Eddy Elliott work his magic on the originals.
So many guitars; So little time ..
- Dennisthe Menace
- Moderator
- Posts: 4981
- Joined: Mon May 05, 2008 8:40 pm
- Location: Ft Lauderdale Florida
- Contact:
Re: Celebrity Q's
Jeremy,
Sounds like you're leaning more towards the 70s set up with the Humbuckers....
This was the set up for the 70s with Mosrite Humbuckers.....


Sounds like you're leaning more towards the 70s set up with the Humbuckers....
This was the set up for the 70s with Mosrite Humbuckers.....


make the Mos' of it, choose the 'rite stuff.
.........Owner of 9 Mosrites...
.....proud owner and documented:
1963 "the Ventures" Model s/n #0038
http://www.thevintagerockproject.com/
.........Owner of 9 Mosrites...
.....proud owner and documented:
1963 "the Ventures" Model s/n #0038
http://www.thevintagerockproject.com/
Return to “Mosrite & Clone, Projects, Parts & Accessories Q&A”
Who is online
Users browsing this forum: No registered users and 65 guests